条件に該当する製品674件
-
VME-3126
Abaco Systems （旧GE Intelligent Platforms） パラレル VMEbus 鉄道/交通 生産中止品(EOL)・8 or 16 isolated input channels with active guards ・16-bit data ・1,500 VDC (1,000 VAC) isolation, input-to-input and input-to-VMEbus ・Digitizer per channel ・Input ranges of ±50 mV to ±10 V, software-selectable on channel-by-channel basis ・Software-controlled bandwidth, 0.05 to 26 Hz (6 pole low pass filters implemented with internal DSP) ・DSP-based offset and gain correction in real-time ・DSP supported E2PROM stores calibration coefficients (no trimpots) ・Conversion rate of 100 SPS (samples per second) per channel ・RTD excitation under software control (200 mA/400 mA per channel) ・Open transducer detection under software control ・Supported by GE Intelligent Platforms Embedded System's I/O controllers ・Optional current termination resistors ・Optional increased input range
-
VME-3418
Abaco Systems （旧GE Intelligent Platforms） アナログI/O VMEbus 鉄道/交通 生産中止品(EOL)・Constant current or constant voltage bridge excitation ・Open sensor detection ・Individual sensor excitation for each channel ・Four-, three-, or two-wire resistance temperature detectors (RTDs); prescaled RTD ranges available ・Full, half, or quarter strain gauge bridges, with on-board bridge completion ・Isolated to 1,000 VDC or 700 VRMS in two groups of four channels ・8 isolated strain gauge and RTD signal conditioning channels ・Input ranges selectable from ± 10 mV to ± 10 V ・Optional low pass input filters; 4, 40, or 400 Hz ・Buffered high-level analog outputs
-
VME-4105
Abaco Systems （旧GE Intelligent Platforms） アナログI/O VMEbus 物理 天体 生産中止品(EOL)・2- or 4-quadrant multiplier option ・0 to -10 V option ・+/-10 V outputs ・8-channel analog output ・12-bit DAC per channel ・Jumper-selectable P2 or front panel outputs
-
VME-4900
Abaco Systems （旧GE Intelligent Platforms） アナログI/O VMEbus 物理 天体 生産中止品(EOL)・Model VME-4900-218R is directly compatible with high power synchro booster amplifiers ・1.5, 4.5, and 5.0 VA outputs ・Nonprivileged or supervisory short I/O ・Compatible with GE Embedded Systems Intelligent I/O Controller product line ・Supports real-time and off-line fault detection and isolation ・AMP D-type connector (no. 206584-1) for front panel field connection ・Front panel fail LED ・Internal transformers ・3- or 4-wire output for driving synchros or resolvers, respectively ・14-bit converter with an overall accuracy of ±4 arc minutes ・Model VME-4905 is also available with 5.0 VA outputs
-
VME-1150B
Abaco Systems （旧GE Intelligent Platforms） パラレル VMEbus 鉄道/交通 生産中止品(EOL)・64 optically coupled digital inputs ・5 V to 48 VDC input range ・High isolation, 1,000 V sustained, 7,500 V pulsed ・Double Eurocard form factor with front panel ・8- or 16-bit data transfers ・Dual I/O connectors
-
VME-1184
Abaco Systems （旧GE Intelligent Platforms） カウンター/タイマー VMEbus 鉄道/交通 生産中止品(EOL)・Front panel inputs for configurable counter/quardrature input with daisy chaining capability ・Available with either a standard VME front panel or the IEEE 1101.10 front panel (see ordering options) ・COS detection is programmable on an individual channel basis ・Sequence-of-Event (SOE) monitoring ・Programmable interrupt vector ・COS data is captured in 512 states deep FIFO ・Contact debounce is software selectable ・Front panel LED status indicator for each input ・Input voltage range is field configurable on a channel-by-channel basis (5V, 12V or 24-28V) ・32 channels of optically isolated digital Change-of-State (COS) Inputs connected through the VME P2, rows A and C
-
VME-2120
Abaco Systems （旧GE Intelligent Platforms） パラレル VMEbus 鉄道/交通 生産中止品(EOL)・8-, 16-, or 32-bit transfers ・High reliability DIN-type I/O connectors ・Compatible with Intelligent I/O Controllers ・Output clamp diodes for inductive flyback protection ・High breakdown voltage (55V) ・or inductive loads ・Automatic surge current shutdown protection option ・Thermal shutdown protection option for driving incandescent ・High current drivers (600mA sink) ・64 bits of high voltage outputs
-
VME-2232A
Abaco Systems （旧GE Intelligent Platforms） RELAY VMEbus 鉄道/交通 生産中止品(EOL)・32 relay output channels (one form C relay per channel) ・Contact ratings ・60W, 50 VA maximum switching power ・220 VDC, 250 VAC maximum switching voltage ・2A maximum switching current ・3A maximum carry current ・Optional contact protection electronics for DC operation ・8-, 16-, or 32-bit data transfers ・Built-in-Test (all active components are tested) ・Front panel with fail LED ・Compatible with the Intelligent I/O Controllers ・VxWorks driver available ・Software compatible with the VMIVME-2532 and the VMIVME-2533
-
VME-1128
Abaco Systems （旧GE Intelligent Platforms） パラレル VMEbus 防衛 生産中止品(EOL)・Complies with the VMEbus Specification Rev. C.1 ・High reliability DIN-type I/O connectors ・Double Eurocard form factor (6U) ・Open circuit provides logic zero or (jumper-selectable) logic one ・A24:A16:D32/D16/D08 (EO): slave: 39/3D:29/2D ・Front panel with fail LED ・On-board Built-in-Test logic for fault detection and isolation ・Each group of eight inputs is jumper selectable to monitor voltage source or current sinking signals ・128 bits of high-voltage digital inputs
-
VME-2128
Abaco Systems （旧GE Intelligent Platforms） パラレル VMEbus 鉄道/交通 生産中止品(EOL)・Front panel with fail LED ・Sockets are provided for warming resistors, which are supplied by the user ・Optional pull-up resistors for electronic switch outputs ・A24:A16:D32/D16/D08 (EO): slave 39/3D:29/2D:6U form factor ・VMEbus compatible (ANSI/IEEE STD 1014-1987 IEC 821 and 297) ・Thermal shutdown protection ・High breakdown voltage (55 V) ・Output clamp diodes for inductive flyback protection ・Compatible with Intelligent I/O Controllers ・Built-in-Test logic for fault isolation ・High-current drivers (600 mA sink) ・Automatic surge current shutdown protection ・128 bits of high-voltage outputs
