条件に該当する製品279件
-
VME-2534
Abaco Systems (旧GE Intelligent Platforms) パラレル VMEbus 防衛 生産中止品(EOL)・Front panel with fail LED ・100 percent testing of all active components (including output drivers) ・Built-in-Test (off-line and real-time support) ・32 bits of high-voltage inputs ・P2 I/O connection (no front panel connectors) ・32 bits of high-voltage outputs
-
PIO-2
Abaco Systems (旧GE Intelligent Platforms) カウンター/タイマー VMEbus 物理 天体 生産中止品(EOL)・All I/O through the P2 connector ・Change of state monitoring for all inputs ・6 programmable 16-bit counter/timers ・Input filtering and high voltage spike protection ・Outputs switch up to 1.0 Amp (1.5A option) ・Inputs and outputs optically isolated ・32 parallel I/O lines for monitoring and controlling applications ・VMEbus slave ・Comprehensive BIT ・6U VME form factor
-
VME-1182
Abaco Systems (旧GE Intelligent Platforms) デジタルI/O VMEbus 通信・ キャリア 生産中止品(EOL)・Interrupt level is user selected ・Complies with ANSI/IEEE STD C37.90.1-1989 surge protection when used with companion suppression panel (e.g., VME-3459) ・64 optically isolated inputs ・Multifunctions available per channel: COS; SOE; pulse accumulation; programmable debounce times; time tagging ・Short or standard, supervisory, nonprivileged, or either access ・COS selections (disabled), rising edge (low-to-high transition), falling edge (high-to-low transition), or any edge ・COS functions software controlled on a channel-by-channel basis ・1.0 ms measurement resolution ・Debounce times software controlled on channel-by-channel basis ・Pulse accumulation (0 to 65,535 pulses) ・SOEs monitoring on channel-by-channel basis ・5 to 60 VDC or 110 to 240 VAC ・1,500 VDC or 1,100 VRMS channel-to-channel and channel-to-VMEbus isolation
-
VME-6015
Abaco Systems (旧GE Intelligent Platforms) デジタルI/O VMEbus 物理 天体 生産中止品(EOL)・— Break generation and detection ・— Parity, overrun, and error detection ・— Even, odd, or no parity ・— 1, 1 1/2, or 2 stop bits ・Asynchronous features ・— 5, 6, 7, or 8 bits/character ・Double Eurocard form factor ・Four programmable baud rate generators ・Uses four industry-standard 25-pin subminiature D connectors ・Modem control lines for each channel ・Self-test capability ・Programmable interrupt capability ・0 to 1 Mbaud data rate ・RS-232C, RS-423, RS-422A, and RS-485 compatible ・Fully programmable synchronous/asynchronous operation ・Four full-duplex channels ・A16:D8 ・Synchronous features
-
VME-3128A
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 通信・ キャリア 生産中止品(EOL)・Continually digitizes all input channels and stores the results ・Program-selectable scanning of 16, 32, 48, or 64 channels ・58 kHz conversion rate ・14-bit A/D conversion ・64 differential or single-ended inputs ・6 operating modes ・Programmed VMEbus interrupts ・User-programmable interval timer
-
VME-3123A
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 物理 天体 生産中止品(EOL)・Built-in-Test ・High throughput with channel pairing ・Digital calibration: no channel trimmers ・Simultaneous sample-and-hold inputs ・16-bit A/D converters: one per channel ・or 16 active channels ・16 differential analog input channels ・16 Channels with Simultaneous Sample-and-Hold Inputs ・16-bit High Throughput Analog Input Board ・internal references applied to channel inputs: all active devices tested
-
VME-3125A
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 物理 天体 生産中止品(EOL)・Applications: Instrumentation in 3U Form Factor, Isolated Analog Inputs, Isolated Transducer Inputs, Ground Loop Elimination, Data Acquisition Systems, Medium-Rate Voltage Monitoring, Process Monitoring, Temperature Monitoring ・1,000 V analog GND/digital GND isolator ・Low pass input filters: 50 kHz, optional 40 Hz ・Pull-down resistors prevent floating inputs ・offset binary or two's complement ・Overvoltage protected inputs ・Selectable data coding ・Input connector compatible with both discrete wire and ribbon cables ・Jumper-programmable gains of x1, x10, x100 ・Selectable A/D ranges of +/-5 V, +/-10 V, 0 to +10 V ・Supports real-time Built-in-Test ・40 kHz aggregate conversion rate ・Input ranges from +/-50 mV to +/-10 V ・Isolated channel-to-bus ・common channel-to-channel ・Autoscanning ・continuously digitizes inputs and stores results in dual-ported data registers ・32 single-ended or 16 differential inputs ・Operating Systems: Windows NT, Linux, VxWorks, QNX
-
VME-3122A
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 防衛 生産中止品(EOL)・Three scan modes ・Three trigger modes ・Continually digitizes selected input channels and stores the results ・Program-selectable scanning of 1, 8, 16, 32, 48, or 64 channels ・Software-selectable conversion rate (100 kHz maximum) ・16-bit A/D conversion ・64 differential or single-ended inputs
-
VME-3113B
Abaco Systems (旧GE Intelligent Platforms) デジタルI/O VMEbus 防衛 生産中止品(EOL)・Powers up in autoscanning mode-no software initialization required ・Continually digitizes all input channels and stores the results in dedicated channel dual-port registers (autoscanning mode) ・64 differential or single-ended inputs ・Supports real-time and off-line Built-in-Test
-
VME-4905
Abaco Systems (旧GE Intelligent Platforms) デジタルI/O VMEbus 防衛 生産中止品(EOL)・Nonprivileged or supervisory short I/O ・5 VA, 2 VA (transformer output), or 0.024 VA options ・Amp D-type (no. 206584-1) ・Internal transformers (400 Hz options) ・Front panel fail LED ・3- or 4-wire output for driving synchros or resolvers ・14-bit converter with an accuracy as high as ±1 arc minute (±4 arc minutes is standard) ・Supports off-line and on-line fault detection and isolation ・Compatible with Intelligent I/O Controllers