条件に該当する製品279件
-
AFDX-E1000 Series
Abaco Systems (旧GE Intelligent Platforms) 通信I/O VMEbus 防衛 生産中止品(EOL)・Software-loadable AFDX stack for rapid deployment ・Air- or conduction-cooled COTS End System ・Single or dual AFDX channels in a single slot ・PowerPC processor ・Intelligent and flexible AFDX End System
-
Abaco Systems (旧GE Intelligent Platforms)
Abaco Systems (旧GE Intelligent Platforms) パラレル VMEbus 鉄道/交通 生産中止品(EOL)・Supports 8- or 16-bit transfers ・High isolation, 1,000 V sustained, 7,500 V pulsed ・Jumper-selectable nonprivileged or supervisory short I/O transfers ・Filtered input debouncing option ・High reliability DIN-type input connector ・5, 12, 24, and 48 V input option ・Wide variety of input signal conditioning ・Contact sense or voltage source options ・COS interrupts
-
VME-4150
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 防衛 生産中止品(EOL)・Static readback data registers simplify program control ・Optical data coupling provides full galvanic isolation ・4-, 8-, and 12-channel configurations ・0.05 percent accuracy for voltage outputs, 0.08 percent for current loop outputs ・Available with 4 to 20 mA current outputs ・10 mA load capacity for voltage outputs over full +/-10 V range ・12-bit resolution ・12 fully isolated analog outputs ・Up to 1,500 VDC isolation, channel-to-channel and channel-to-bus (1,000 VDC standard) ・Voltage output ranges selectable as +/-2.5, +/-5, or +/-10 V ・Front panel access
-
A429-V2
Abaco Systems (旧GE Intelligent Platforms) 1553/ARINC VMEbus 防衛 生産中止品(EOL)・VME form factor ARINC429 ・Sink data can be filtered and received in a current value table, local and/or global monitor buffers ・IRIG available. Also available with a Special Configuration that routes the I/O to P2 connector. ・Source lists can be added to any channel
-
800-202
Abaco Systems (旧GE Intelligent Platforms) 通信I/O VMEbus ロボット 半導体製造機 生産中止品(EOL)VME64 Bus Adapter with DMA ・Power requirements: 2.5A at 5V ・Meets IEEE 1014C specifications ・Operating temperature: 0 to +60 degrees C ・Storage temperature: -40 to +85 degrees C ・Humidity: 5% to 90%, non-condensing
-
VME-3113A
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 鉄道/交通 生産中止品(EOL)・Powers up in autoscanning mode-no software initialization required ・Continually digitizes all input channels and stores the results in dedicated channel dual-port registers (autoscanning mode) ・64 differential or single-ended inputs ・Supports real-time and off-line Built-in-Test
-
VME-3123
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 物理 天体 生産中止品(EOL)・Built-in-Test ・internal references applied to channel inputs: all active devices tested ・Simultaneous sample-and-hold inputs ・High throughput with channel pairing ・Digital calibration: no channel trimmers ・16-bit A/D converters: one per channel ・or 16 active channels ・16 differential analog input channels ・16 Channels with Simultaneous Sample-and-Hold Inputs ・16-bit High Throughput Analog Input Board
-
VME-3122
Abaco Systems (旧GE Intelligent Platforms) アナログI/O VMEbus 物理 天体 生産中止品(EOL)・Continually digitizes selected input channels and stores the results ・Program-selectable scanning of 1, 8, 16, 32, 48, or 64 channels ・Software-selectable conversion rate (100 kHz maximum) ・16-bit A/D conversion ・64 differential or single-ended inputs ・Three trigger modes ・Three scan modes
-
VME-3125
Abaco Systems (旧GE Intelligent Platforms) パラレル VMEbus 鉄道/交通 生産中止品(EOL)・Applications: Instrumentation in 3U Form Factor, Isolated Analog Inputs, Isolated Transducer Inputs, Ground Loop Elimination, Data Acquisition Systems, Medium-Rate Voltage Monitoring, Process Monitoring, Temperature Monitoring ・1,000 V analog GND/digital GND isolator ・Low pass input filters: 50 kHz, optional 40 Hz ・Pull-down resistors prevent floating inputs ・offset binary or two's complement ・Overvoltage protected inputs ・Selectable data coding ・Input connector compatible with both discrete wire and ribbon cables ・Jumper-programmable gains of x1, x10, x100 ・Selectable A/D ranges of +/-5 V, +/-10 V, 0 to +10 V ・Supports real-time Built-in-Test ・40 kHz aggregate conversion rate ・Input ranges from +/-50 mV to +/-10 V ・Isolated channel-to-bus ・common channel-to-channel ・Autoscanning ・continuously digitizes inputs and stores results in dual-ported data registers ・32 single-ended or 16 differential inputs ・Operating Systems: Windows NT, Linux, VxWorks, QNX
-
VME-3126
Abaco Systems (旧GE Intelligent Platforms) パラレル VMEbus 鉄道/交通 生産中止品(EOL)・8 or 16 isolated input channels with active guards ・16-bit data ・1,500 VDC (1,000 VAC) isolation, input-to-input and input-to-VMEbus ・Digitizer per channel ・Input ranges of ±50 mV to ±10 V, software-selectable on channel-by-channel basis ・Software-controlled bandwidth, 0.05 to 26 Hz (6 pole low pass filters implemented with internal DSP) ・DSP-based offset and gain correction in real-time ・DSP supported E2PROM stores calibration coefficients (no trimpots) ・Conversion rate of 100 SPS (samples per second) per channel ・RTD excitation under software control (200 mA/400 mA per channel) ・Open transducer detection under software control ・Supported by GE Intelligent Platforms Embedded System's I/O controllers ・Optional current termination resistors ・Optional increased input range